Archive for October 2018

Finding the Right Roofing Company

In anticipation of cold weather, we stock up on warm clothes, “re-train” cars in winter tires, we warm the windows of houses, but we do not think about the roof of the dwelling in the first place. Meanwhile, low temperatures, snow, ice affect the roof not in the best way. It is she who first feels all the climatic whims. To not have to patch the roof in the cold, you need to carefully prepare it for the winter. How to do it and what you need to remember about caring for the roof in the cold?

They examine

First you need to carefully inspect the roof. Check that the roofing is securely fastened. If it’s roll roofing materials, feel the joints. The edges should not fall behind. If you are dealing with a metal tile, inspect the screws. They must be fully screwed.

On the roof covered with sheets of ceramoplast or Euroschlire (bitulin, ondulin), pay attention to the protective caps on the hats of roofing nails, screws and screws. They must be closed. This protects the roof from moisture penetration into the under-roof space, as well as from strong gusts of wind that can rip it off. Plus, poorly fixed metal, roofing sheet and metal profile, will rattling. The choice of the right Roofing Repair Company is essential there.

Also make sure that there are no defects on the roof. In the roll coating there should be no breaks. Check the metal tiles for scratches and holes. Even minor damage to the metal coating is better to repair. Otherwise, under the snow, they will be corroded. Scratches are covered with special protective enamel.

  • If a hole is seen in the sheet, it is better to replace it. In extreme cases, apply a temporary patch with a sealing tape. But in the future you still have to change the entire sheet.
  • Also pay attention to the tightness of joints, ventilation and antenna terminals, skylights. Problems, for the first time, seal up with silicone sealant.
  • Such an inspection of the roof must be done not only in preparation for winter, but also after it. Preventive examination twice a year will be enough.

Cleanse

With a clean roof is easier to get any rain. Therefore, on the eve of winter, you need to remove from it branches, leaves, moss, lichen. The same goes for the drainage system. Garbage can seriously hurt her.

Pay attention to the branches of the nearest trees. If the big and old hang over your roof, they should be removed. Otherwise, under the weight of snow and ice, they can fall on the roof and seriously damage it.

Lower The Consumption Of Electricity Using The TDX 20 Refrigerant

Did you know that it is possible to lower the amount of electricity you are using with any machine that uses a refrigerant by switching over to TDX 20? This is a coolant which was developed by the company Bluon, an industry leader that is really changing the way that many machines operate. For example, when this is used by machines that produce electricity, fewer CO2 emissions are produced. In addition to this, if there is ever any leakage of the coolant, it will in no way harm the ozone layer. This was a major reason that people began to reduce the use of R-22. In 2020, it will be completely eliminated. Whether you are using some type of HVAC-R machine, or if you do have a large facility that is producing electricity on a daily basis, you can make the wise decision to start using TDX 20 refrigerant.

 

How Can It Lower Your Electricity Consumption?

An example of how this is able to lower your energy consumption is in the production of electricity. The reason that CO2 is produced in such abundance by these machines is that they are working very hard to make the electricity. Part of this process involves the use of the coolant. In the past, the primary one was Freon. By changing out this coolant for TDX 20, you are able to quickly see that your motors are going to be operating much more easily. As they work, they are constantly trying to keep the machinery cool. There is only so much heat that can be extracted by coolants. To do so, the coolant is compressed so that it becomes a gas, and the heat that is absorbed is dissipated outside using an evaporator coil. However, it is the condenser coil that uses the most electricity because it is working harder when more heat needs to be removed. It is because TDX 20 is so efficient at extracting heat, even at a lower pressure, that it actually makes these electricity producing machines operate at a lower temperature. They are not working as hard, and therefore the consumption of electricity to run the motors is lower, thus lowering CO2 emissions significantly.

 

Is This The Same For All Machinery?

This particular coolant is very effective when used with machines that do require substantial amounts of cooling. If you are operating a device that does not use coolant at all, it would not be a consideration. Another example would be a refrigeration unit. These are going to use condenser coils. These are going to compress the coolant, and they typically must do so with great effort so as to extract as much heat as possible. However, this product from Bluon is even more efficient than Freon at lower amounts of pressure. That’s why it’s so important to switch over. Of course, there is the added benefit of never having to worry about leaking coolant causing problems with the ozone layer. TDX 20 might be similar to Freon, and more efficient, but it will never contribute to a depletion of ozone.

 

Is This Worth The Investment?

This is certainly worth the investment, but the reason that people question investing in this particular coolant is that it tends to be at a much higher price. Part of the reason is all of the research and development that went into creating it. It is well worth the money you will pay. They have created a coolant that is like no other. To imagine that you can run the same machinery for 25% less electricity, you can start to see how this, in the long term, is a very good deal. You will probably recoup all of your money within a few years, and that savings that you will have on purchasing electricity will soon be more money for your business.

 

What If You Already Have Machines That Are Using Another Coolant?

If you do have a machine or two that is currently using R-22, you know that you have to replace this very soon. Therefore, you may as well consider replacing it with TDX 20 and start benefiting from the way it works. Not only will your machines use less electricity, but CO2 emissions will diminish thus allowing you to contribute to lowering the threat of global warming. As mentioned earlier, it is also a substance that will never hurt the ozone layer which means you won’t have to worry about any type of leakage.

 

Other Reasons To Use TDX 20

There are several other reasons why you should consider switching over to TDX 20. First of all, it is using chemicals that are outstanding when it comes to extracting heat. Tetrafluoroethane R134 is one of those components that makes up this product by Bluon. This is regarded as a high temperature substance. It is easily able to remove moisture. It does so by utilizing compressed air, and at the same time will prevent electric discharges, plus it will absorb thermal energy very easily. The other components include R32, R125, and R227. There are a few other components that all work together to create the most efficient coolant that has ever been made. As you can see, a substantial amount of time and effort went into creating this unique blend. It is not simply a chlorofluorocarbon like Freon. It is designed to become the most efficient coolant you have ever utilized and will likely be the one you stay with four years to come.

 

If lowering the consumption of energy with the machines you are using sounds like a good idea, you should schedule a time for an HVAC professional to replace your existing coolant with TDX 20. Bluon has truly created the most unique and efficient coolant in the world. You need to look past the higher price that it will likely have by comparison to its competitors. In the long run, this is a wise investment. It’s also a profitable investment once the first few years are over. You will recoup your investment easily, and you will be doing your part to contribute to lowering CO2 emissions significantly.

 

  • Partner links